INTERMODAL PROCESS
1. Type your flat cars into a switch list. If they show LLOR LE/PAC, you will need to Deramp them. If they show E/RMT continue to step 8.
DERAMP PROCESS
2. Select intermodal.
3. Select Available to De-ramp.
4. Now select your flat car. (cars are in blue in alpha numeric order)
5. After all cars are highlighted for that car, then select De-ramp.
6. Make sure date and time are good. (make time show on the previous hour) and hit OK.
7. Close to get back to switch list and hit F5. Car should now show below. If car shows E/RMT, continue steps 2 – 7 on all the flat cars.
8. Select intermodal.
9. Select Available to Ramp then Locate.
10. Type in the containers hitting enter after each one. (if there are more than 6 numbers on the container, only type in the first 6 numbers). As you type, they will highlight in blue. Hit OK. (If cars are not showing up, they are NOT billed.)
11. Select Ramp
12. Select your flat car. Hit OK.
13. Change the time to show 15” after your original time. Hit OK.
14. Go back to your switch list and F5.
15. Repeat steps 8 – 14 on all the cars until they all show LL or LE and RLO or RMT.
16. Mail a switch list to yourself to get a PDF of the switch.
17. Reply to the road asking you to ramp cars with the PDF switch you sent to yourself and say "Cars have been ramped".