JXPT INTERMODAL
You will get an email like below from JXPT on intermodal. Select the PDF that has Rail View
It will look like this.
1. Type your flat cars into a switch list. If they show LL/PAC, you will need to Deramp them. If they show E/RMT continue to step 8.
DERAMP PROCESS
2. Select intermodal.
3. Select Available to Deramp.
4. Now select your flat car. (cars are in blue in alpha numeric order)
5. After all cars are highlighted for that car, then select Dermp.
6. Make sure date and time are good. (make time show on the previous hour) and hit OK.
7. Close to get back to switch list and hit F5. Car should now show below. If car shows E/RMT, continue steps 2 – 7 on all the flat cars.
8. Select intermodal.
9. Select Available to Ramp then Locate. 
10. Type in the containers hitting enter after each one. (if there are more than 6 numbers on the container, only type in the first 6 numbers). As you type, they will highlight in blue. Hit OK. (If cars are not showing up, they are NOT billed.) 
11. Select Ramp
12. Select your flat car. Hit OK. 
13. Change the time to show 15” after your original time. Hit OK.
14. Go back to your switch list and F5.
15. Repeat steps 8 – 14 on all the cars until they all show LL or LE and RLO or RMT.
16. Mail a switch list to yourself to get a PDF of the switch.
17. Once you receive the PDF, you will need to send it in an email to the proper addresses and say “Billing has been applied and cars have been ramped.”
- NS email include
- Babel, Frances frances.babel@nscorp.com
- Minicucci, Luke luke.minicucci@nscorp.com
- JXPT Crew jxptcrew@watco.com
- Timothy D. Hurse Timothy.Hurse@watco.com
- CS Request and JXPT Billing
- CSXT email
- JXPT Crew jxptcrew@watco.com
- Timothy D. Hurse Timothy.Hurse@watco.com
- CS Request and JXPT Billing